Yes, this is not a 12-volt system. This is for the 1-inch Gas Trash Pumps & super cool!! I will agree This is the next step before an AR45 I’d say Mike has come up with this super slick design to tie in this new system hitting the market, check him out my man The… Read more

You must supply 12 volts to the pump. Stop burning up pumps! Read more

Don’t guess that’s how problems start. Do it right & get the most out of your system. The more power you have the more of a distance you will get. Hope this helps fix your pump issue. Read more

This is why you must run the correct size wire and make sure you’re getting the correct voltage. Jumping grounds, Running 2 8 GPM, and a heater off 1 battery 🤔 But it’s AGM 👌 what does that mean? I don’t believe in sharing power on main units. Now everything is down,3 machines not just… Read more

This stuff works amazing & protects your electrical connections We use this on everything from boats, 4 wheelers, side by sides & of course pressure washing trailers. Read more

This is all the info that I run on my trailer. If I change 14 feet of wire to 15, I go into the red on voltage drop. Please remember that my 14 feet of power/ground is only 7 feet in total. Why Pressure Switches are burning up faster. If you have pumps with broken… Read more

A few guys got them and like them. One less thing to install. Check them out Here Read more

NOTE: Further adjustments should not be necessary although it may take severaldays of operation before all the air has been purged and the system is stabilized.y Rapid On/Off Cycling must be limited to no more than 6 times per minute,even if the pump is operating in the Continuous Duty zone. Cycling couldcause the motor to… Read more

You must have 12 volts at the pump to keep these pumps running the way they should when you supply less than 12 volts and use under gauge wire. You create dirty voltage. Lower Voltage means Higher amps & spikes. Now you are cooking the Pressure Switch because the PS is rated at 15.1 amps.… Read more